Insinkerator EVOLUTION PLUS 1000 EC Ecological waste disposer with cutlery saving cap 1 hp

Insinkerator EVOLUTION PLUS 1000 EC 1974100 - Ecological disposer with cutlery-saving cap

This E1000EC model replaces the former Evolution 200 model , and is the top of the range.
This model of the Evolution Plus line is characterized by the four-stage dissipation technology, it is the quietest of the range . It dissipates most of the food, the waste is reduced to particles and discharged.

It can quickly and efficiently shred chicken bones, fish bones, fruit and vegetable peels, corn cobs, nut shells and fruit pits. It can even easily shred avocado and banana peels, reducing the amount of food waste that ends up in your kitchen garbage can, so that unpleasant odors from the latter will become a distant memory.

The improvements of the new model compared to the previous one are:
• 1 HP motor for maximum shredding power and durability
• Motor Power: 450w
• 4-stage shredding technology for even finer shredding
• Lift & latch technology and rubber grips on the liner for easier installation in new or existing kitchens and in most sinks.
• Slightly more compact dimensions.

Technical data sheet
Height: 31.2 cm
Width: 20.9 cm
Type: Waste disposer
Exhaust connection: 40 mm
Automatic button hole size: 35mm
Engine power: 1 hp
On/Off Control: Pneumatic button or wall switch
Grinding chamber capacity: 980 ml
Grinding chambers: 4 phases
Motor protection: Manual overload reset
Average electricity consumption: 2-3 KWh per year
Average daily water consumption per person: 5 l

Characteristics
- 60% quieter than standard models, thanks to Quietest SoundSeal technology
- Advanced shredding for hard and fibrous food waste
- 4-stage multi-shredding technology. Fine shredding (compared to 1-stage and 2-stage multi-shredding technology)
- Crushes all food waste into tiny particles.
- Built-in easy to install chrome air switch inverter to automatically increase motor power up to 4 times when needed.
- Steel shredding chamber (980ml capacity) and upper steel shredding elements process all waste.
- Removable splash guard
- Steel basket cutlery saver cap included
- Auto-Reverse system for longer product life and trouble-free operation.
- Engine: 1 HP
- Volts 220-240. HZ: 50-60
- Safe to use with properly maintained septic tank. Drain connection: 1.5" cushioned slip joint
- Supplied with Schuko socket
- Lubrication: Upper and lower bearings permanently lubricated
- Exhaust connection: 3.8 cm damped sliding joint
- Up to 5 years limited warranty by Insinkerator
- Only fits sinks with a standard 3.5 inch (90 mm) hole
- If the sink thickness exceeds 20mm or the sink is made of marble or stone, it is necessary to additionally purchase the Insinkerator sink flange item 1975491 (available for purchase among the accessories at the bottom of the page)